Garmin TR-1 Manuel d'instructions

Cylinder and Bracket Mounting InstructionsSuzuki 9.9 & 15 HP: 1997 & NewerJohnson/OMC 9.9 & 15 HP: 2002-20071PN 906-1090-00TR-1 Gold

Step Fifteen:Turn the motor to retract the cylinder rod into the cylinder. Check that the cylinder rod is still free to retract at least a little mo

Step Sixteen: With the cylinder properly adjusted, secure it by tightening the hex jam nut (item #32) against the Rod eye end of cylind

Parts List:Item Number Part Number Name Qty.Cylinder Mounting Kit 120-1090-001 330-1091-00 Standoff, Spacer 22 130-1092-00 Bracket, Rod Eye Mounting 1

Minimum Tools Needed: 1- 13 mm Wrench 1- 12mm Wrench 1-1/2 Wrench 1- 7/16 Wrench 1- #1 Phillips Screwdriver 1- Thread Locker (Loctite or sim

Caution: You are mounting this steering cylinder to a vibration isolation mount on your motor. Note; that the factory bolts and screws have had threa

Fig. 3Step Three:Remove the lower nut and washer from the lower vibration isolation shroud. See Fig 3 (keep this nut and washer also)Fig. 4Step Four:R

Fig 5Step Five:Place the “U” Bolt (item #16) around steering pivot tube as pictured in g. 5.Fig 6Step Six:Place the Rod eye Bracket (item # 2

Fig 8Step Eight:Use thread lock on the phillips screw (item #20). Put the channel snubber clamp (item#5) behind the channel with the ear behind the

Fig. 11Step Eleven:Place the stern pivot pin (item #3) into the rear of the channel as pictured in g. 11.Fig. 12Step Twelve:Slide the cylinder rod ey

Step Thirteen:The Flange that holds the rod eye pin may need to be aligned (depending on how tight you tighten up the “U” bolt). Check the position