Garmin GPSMAP 180 Manuel d'utilisateur télécharger pdf (Page 85)

Oscillator Needs AdjustmentThe GPSMAP 180 has detected excessive drift in

its internal oscillator, which may result in longer acquisition times. Take the

unit to an authorized GARMIN service center for adjustment.

Poor GPS CoverageThe GPSMAP 180 cannot acquire the necessary number

of satellites to compute a position.

Power Down and Re-initThe GPSMAP 180 cannot calculate a position due to

abnormal satellite conditions. Power down and verify the last position shown by

other means.

Proximity AlarmYou have entered the alarm radius for the proximity way-

point indicated.

Proximity List FullYou have used all nine proximity waypoints.

Proximity Overlaps Another Prox WyptThe alarm radius specified overlaps

the area specified for another proximity waypoint.

RAM has FailedThe random access memory has failed and the unit is not

operable. Take your unit to an authorized GARMIN service center for repairs.

ROM has FailedThe units permanent memory has failed and the unit is not

operable. Take your unit to an authorized GARMIN service center for repairs.

Received Invalid WaypointA waypoint was received during upload transfer

that has an invalid identifier.

Receiver has FailedA failure in receiver hardware has been detected. If this

message persists, do not use the unit and take it to an authorized dealer for

repair.

Route Already ExistsThe route number you are trying to copy to is already

used.

Route Does Not ExistThe route number you are trying to use or copy is not

defined.

Route is FullYou have attempted to add more than 30 waypoints to a route.

Route Memory is FullYou have attempted to create more than 20 routes.

Route Waypoint was DeletedA route waypoint entered does not exist in the

database and has been deleted from the route.

SECTION

APPENDIX

Messages

RTCM Input has FailedDGPS data being received has been lost. You are no longer

receiving the beacon signal.

Searching the SkyThe GPSMAP 180 is searching the sky for almanac data.

Stored Data was LostAll waypoints, routes and almanac data has been lost due to

internal battery failure.

There is No RTCM InputThe beacon receiver is not properly connected or baud rates

do not match.

Timer Has ExpiredThe countdown timer has expired.

Track Memory is FullThe track memory is full and no additional track plot will be

recorded until the track memory has been cleared or set to wrap mode.

Wypt Already ExistsThe waypoint name youve entered already exists in memory.

Waypoint Memory is FullYou have used all 250 waypoints in the GPSMAP 180 system.

1 2 ... 80 81 82 83 84 85 86 87 88 89 90 ... 95 96

Commentaires sur ces manuels

Pas de commentaire

Garmin GPSMAP 180 Manuel d'utilisateur Page 85

Commentaires sur ces manuels

Produits connexes et manuels pour Matériel informatique Garmin GPSMAP 180