Garmin GPSMAP 182C Manuel d'utilisateur télécharger pdf (Page 106)

100 GPSMAP 182/182C Owner’s Manual

APPENDIX > INSTALLING AND REMOVING DATA CARDS

Installing and Removing Data Cards

The GPSMAP 182/182C uses optional Garmin marine BlueChart

and MapSource data cards to display digital charts and maps

on-screen. Data cards are installed in the card slot located at the

bottom right of the unit. Data cards can be installed or removed at

any time, whether the unit is on or off.

To install a data card:

1. Open the card door by pressing together on the two handles

at the bottom of the door and lifting it up and open.

2. Insert the card, with the label facing front and the handle

bottom, into the slot.

3. Firmly push the card into the unit. It in not necessary to

force the card and about 1/2" is still exposed when it is

properly inserted. If the unit is on, a conﬁrmation tone

sounds and a message displays on-screen noting the card

details when the card is properly installed and accepted.

4. Close the cover.

If you insert a data card and get a “card format not recognized”

message, try removing the card and reinserting it. If the card is still

not recognized, contact Garmin Product Support or your Garmin

dealer for assistance. Data cards are not waterproof and should

not be exposed to moisture or excessive static charges. Data cards

should be stored in the case supplied with the card.

To remove a data card:

1. Open the card door by pressing together on the two handles

at the bottom of the door and lifting it up and open.

2. Grasp the card handle at the bottom and pull down ﬁrmly.

3. If the unit is on, a conﬁrmation tone sounds when the data

card has been removed.

The ﬁrst time you insert a data card, the unit takes a few seconds to

read the card.

After the data card is read, a summary screen appears. Press

ENTER to acknowledge.

1 2 ... 101 102 103 104 105 106 107 108 109 110 111 ... 125 126

Pas de commentaire

Garmin GPSMAP 182C Manuel d'utilisateur Page 106