Garmin Software Version 0719.09 Guide de l'utilisateur Page 144

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 152
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 143
Garmin G1000 Cockpit Reference Guide for the Socata TBM 850
190-00708-04 Rev. A
Appendix
128
Flight
InstrumentsEAS
Nav/Com/
XPDR/AudioAFCSGPS Nav
Flight
PlanningProcedures
Hazard
Avoidance
Additional
Features
Abnormal
Operation
Annun/
AlertsAppendixIndex
1)
With the system OFF, insert the SD card containing the new navigation
database version into the top card slot of the MFD.
2)
Verify that an SD card is inserted in the bottom slot of each PFD and the
MFD.
3)
Turn the system ON. A prompt is displayed.
4)
Press the YES Softkey. The navigation database is copied to the SD card in
the bottom card slot of the MFD.
5)
After the navigation database files are copied to the bottom SD card, press
any key to continue, as instructed.
7)
Again, press any key to continue as instructed on the display.
8)
Press the NO Softkey. The display now starts in normal mode. Since the
database effective date is not yet valid, it should not be loaded as the
active database. The display now starts in normal mode. Do not remove
power while the display is starting.
9)
Press the ENT Key to acknowledge the startup screen.
10)
Turn the large FMS Knob to select the AUX Page group on the MFD.
11)
Turn the small FMS Knob to select the System Status Page.
12)
The new database is copied to the SD card in the bottom card slot of each
PFD. Progress can be monitored in the SYNC STATUS field. When copying
is finished, ‘Complete’ is displayed.
13)
Turn system power OFF.
14)
Remove the SD card from the top card slot of the MFD.
15)
Turn system power ON.
16)
Press the ENT Key to acknowledge the startup screen.
17)
Turn the large FMS Knob to select the AUX Page group on the MFD.
18)
Turn the small FMS Knob to select the System Status Page.
19)
Press the Display Database Selection Softkey to show standby navigation
database information for each display (MFD1 DB, PFD1 DB, PFD2 DB).
Verify the correct standby navigation database cycle information is shown
for each display.
Vue de la page 143

Commentaires sur ces manuels

Pas de commentaire