Garmin Software Version 0720.14 Guide de l'utilisateur Page 149

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 156
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 148
G1000 Cockpit Reference Guide for the Piper PA-46 Mirage/Matrix
190-01107-03 Rev. A
Appendix
133
Flight
Instruments EICAS
Nav/Com/
XPDR/Audio AFCS GPS Nav
Flight
Planning Procedures
Hazard
Avoidance
Additional
Features
Abnormal
Operation
Annun/
Alerts Appendix Index
12)
Turn system power OFF.
13)
Remove the SD card from the top card slot of the MFD.
14)
Turn system power ON.
15)
Press the ENT Key to acknowledge the startup screen.
16)
Turn the large FMS Knob to select the AUX Page group on the MFD.
17)
Turn the small FMS Knob to select the System Status Page.
18)
Press the Display Database Selection Softkey to show standby navigation
database information for each display (MFD1 DB, PFD1 DB, PFD2 DB).
Verify the correct standby navigation database cycle information is shown
for each display.
Magnetic Field Variation Database Update
At startup, the system compares this version of the MV DB with that presently being
used by each AHRS (GRS1 and GRS2). If the system determines the MV DB needs to
be updated, a prompt is displayed on the Navigation Map Page, as shown in Figure
B-7. Note, in the following example, GRS1 is the first AHRS to indicate an update is
available. In actuality, this is dependent on which AHRS is the first to report status to
the system. GRS2 may be displayed before GRS1. The order is not important, only
that both AHRS be updated.
GRS1 Magnetic Field Variation Database Update Prompt
Loading the magnetic field variation database update:
1)
With ‘OK’ highlighted, as shown in the previous figure, press the ENT Key
on the MFD. A progress monitor is displayed as shown in the following
figure.
Vue de la page 148

Commentaires sur ces manuels

Pas de commentaire