
Garmin G1000 Cockpit Reference Guide for the Socata TBM 850/900
190-00708-05 Rev. A 131
Annunciations & Alerts
Flight
Instruments EAS
Nav/Com/
XPDR/Audio AFCS GPS Nav
Flight
Planning Procedures
Hazard
Avoidance
Additional
Features
Abnormal
Operation
Annun/
Alerts Appendix Index
MISCELLANEOUS MESSAGE ADVISORIES (CONT.)
Message Comments
VNV
– Unavailable. Parallel course
selected.
A parallel course has been selected, causing
the vertical deviation to go invalid.
NON WGS84 WPT
– Do not use GPS
for navigation to [xxxx]
The position of the selected waypoint [xxxx]
is not calculated based on the WGS84 map
reference datum and may be positioned in
error as displayed. Do not use GPS to navigate
to the selected non-WGS84 waypoint.
STRMSCP FAIL
– Stormscope has
failed.
Stormscope has failed. The system should be
serviced.
TRAFFIC FAIL
– Traffic device has
failed.
The is no longer receiving data from the traffic
system. The traffic device should be serviced.
FAILED PATH
– A data path has
failed.
A data path connected to the GDU or the GIA
63/W has failed.
MAG VAR
– Large magnetic
variance. Verify all course angles.
The GDU’s internal model cannot determine
the exact magnetic variance for geographic
locations near the magnetic poles. Displayed
magnetic course angles may differ from the
actual magnetic heading by more than 2°.
SVT
– SVT DISABLED: Out of
available terrain region.
Synthetic Vision is disabled because the aircraft
is not within the boundaries of the installed
terrain database.
SVT
– SVT DISABLED: Terrain DB
resolution too low.
Synthetic Vision is disabled because a terrain
database of sufficient resolution (9 arc-second
or better) is not currently installed.
SCHEDULER [#]
– <message>. Message criteria entered by the user.
CHECK CRS
– Database course for
LOC1 / [LOC ID] is [CRS]°.
Selected course for LOC1 differs from published
localizer course by more than 10 degrees.
CHECK CRS
– Database course for
LOC2 / [LOC ID] is [CRS]°.
Selected course for LOC2 differs from published
localizer course by more than 10 degrees.
[PFD1, PFD2, or MFD1]
CARD
1 REM
– Card 1 was removed.
Reinsert card.
The SD card was removed from the top card
slot of the PFD or MFD. The SD card needs to
be reinserted.
Commentaires sur ces manuels