Garmin Software Version 0719.12 Guide de l'utilisateur Page 161

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 174
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 160
Garmin G1000 Cockpit Reference Guide for the Socata TBM 850/900
190-00708-05 Rev. A
Appendix
145
Flight
Instruments EAS
Nav/Com/
XPDR/Audio AFCS GPS Nav
Flight
Planning Procedures
Hazard
Avoidance
Additional
Features
Abnormal
Operation
Annun/
Alerts Appendix Index
5)
Acknowledge the Power-up Page agreement by pressing the ENT Key or
the right most softkey.
6)
Turn the large FMS Knob to select the AUX Page group on the MFD.
7)
Turn the small FMS Knob to select the System Status Page.
8)
Monitor the Sync Status in the Database Window. Wait for all databases to
complete synching, indicated by ‘Complete’ being displayed.
9)
Remove and reapply power to the system.
10)
Turn the large FMS Knob to select the AUX Page group on the MFD.
11)
Turn the small FMS Knob to select the System Status Page.
12)
Press the Display Database Selection Softkey to show database information
for each display (MFD1 DB or PFD1 DB). Verify the correct database cycle
information is shown for each database for each display.
Updating Terrain, FliteCharts, and ChartView Databases
1)
With system power OFF, remove the Supplemental Data Card from the
bottom card slot of the MFD and PFD.
2)
Copy the updated terrain database to both Supplemental Data Cards. Copy
the updated FliteCharts or ChartView database to one Supplemental Data
Card.
3)
Insert the updated Supplemental Data Cards into the bottom card slot of
the MFD and PFD. The Supplemental Data Card containing the FliteCharts
or ChartView database is inserted in the MFD.
4)
Apply power to the system, check that the databases are initialized and
displayed on the power-up screen. A ‘Verifying’ message may be seen.
If this message is present, wait for the system to finish loading before
proceeding to step 5.
5)
Acknowledge the Power-up Page agreement by pressing the ENT Key or
the right most softkey.
6)
Turn the large FMS Knob to select the AUX Page group on the MFD.
7)
Turn the small FMS Knob to select the System Status Page.
8)
Press the Display Database Selection Softkey to show database information
for each display (MFD1 DB or PFD1 DB). Verify the correct database cycle
information is shown for each database for each display.
9)
Remove power from the system.
Vue de la page 160
1 2 ... 156 157 158 159 160 161 162 163 164 165 166 ... 173 174

Commentaires sur ces manuels

Pas de commentaire