
Garmin G1000 Cockpit Reference Guide for the Socata TBM 850/900
190-00708-05 Rev. C
2
Flight Instruments
Flight
InstrumentsEAS
Nav/Com/
XPDR/AudioAFCSGPS Nav
Flight
PlanningProcedures
Hazard
Avoidance
Additional
Features
Abnormal
Operation
Annun/
AlertsAppendixIndex
CHANGE NAVIGATION SOURCES
1)
Select the CDI Softkey to change from GPS to VOR1 or LOC1. This places
the cyan tuning box over the NAV1 standby frequency in the upper left
corner of the PFD.
2)
Select the CDI Softkey again to change from VOR1 or LOC1 to VOR2 or
LOC2. This places the cyan tuning box over the NAV2 standby frequency.
3)
Select the CDI Softkey a third time to return to GPS.
NOTE:
On some ILS approaches where the glideslope intercept point
is at or in close proximity to the fix prior to the FAF, it is possible to
be above the glideslope when the navigation source automatically
switches from GPS to LOC. The probability of this occurring varies
based on air temperature. Review the Course Deviation Indicator (CDI)
discussion, in the Flight Instruments section of the Pilot’s Guide for
more information on situations where this might occur.
ENABLE/DISABLE OBS MODE WHILE NAVIGATING WITH GPS
1)
Select the OBS Softkey to select OBS Mode.
2)
Turn a CRS Knob to select the desired course to/from the waypoint. Press
the CRS Knob to synchronize the Selected Course with the bearing to the
next waypoint.
3)
Select the OBS Softkey again to disable OBS Mode.
GENERIC TIMER
1)
Select the TMR/REF Softkey, then turn the large FMS Knob to select the
time field (hh/mm/ss). Turn the FMS Knobs to set the desired time, then
press the ENT Key. The UP/DOWN field is now highlighted.
2)
Turn the small FMS Knob to display the UP/DOWN window. Turn the FMS
Knob to select ‘UP’ or ‘DOWN’, then press the ENT Key. ‘START?’ is now
highlighted.
3)
Press the ENT Key to START, STOP, or RESET the timer (if the timer is
counting DOWN, it will start counting UP after reaching zero). Press the
CLR Key or the TMR/REF Softkey to remove the window.
Commentaires sur ces manuels