Garmin POWERLITE CINEMA 200+ Manuel d'utilisateur télécharger pdf (Page 51)

Cleaning and Replacing the Air Filter

Clean the air filter on the bottom of the projector after every 100 hours of use. If it’s not

cleaned periodically, it can become clogged with dust, preventing proper ventilation. This can

cause overheating and damage the projector.

1. Turn off the projector and wait for the P power light to stop flashing.

2. Unplug the power cord and disconnect any cables.

3. Turn the projector over. Use a small vacuum cleaner

designed for computers and other office equipment to

clean the filter, as shown. If you don’t have one, gently

clean the filter using a very soft brush (such as a clean

artist’s paintbrush).

If the dirt is difficult to remove or the filter is broken,

replace it. To purchase a filter, contact your dealer or call

Epson at (800) 463-7766 to find an Epson authorized

reseller or visit http://www.epsonstore.com (U.S. sales

only). Request part number

V13H134A04. In Canada,

call (800) 463-7766 for dealer referral.

4. If you need to replace the filter, release the tab and lift

the cover up.

5. Remove the old filter and replace it with a new one.

6. To replace the cover, insert the tabs and press down until the cover clicks into place.

PowerLite Cinema 200+.book Page 51 Thursday, August 18, 2005 2:37 PM

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 79 80

Pas de commentaire

Garmin POWERLITE CINEMA 200+ Manuel d'utilisateur Page 51