Garmin SA01535Wi_D Guide de l'utilisateur Page 20

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 174
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 19
Garmin G1000 Cockpit Reference Guide for the Beechcraft 200/B200 Series
190-00929-04 Rev. A
2
Flight Instruments
Flight
Instruments
Nav/Com/
XPDR/AudioAFCSGPS Nav
Flight
PlanningProcedures
Hazard
Avoidance
Additional
FeaturesAnnun/AlertsAppendixIndex
SELECTING DG MODE (GRS 7800 INSTALLATIONS ONLY):
NOTE: When operating the G1000 in DG Free Mode (GRS 7800 installations
only), the heading information used by some system components (e.g. GTS
8000, AFCS, and GWX) will be different from the heading displayed on the
GDU by an amount equal to the difference between the current Magnetic
Field Variation Database (MV DB) value, and the MV DB value when DG Free
Mode was activated. Due to the convergence of isogonic lines, this condition
is most noticeable at or near the North and South poles.
1)
Press the PFD Softkey.
2)
Press the HDG MODE Softkey.
3)
Press the DG FREE Softkey to activate DG mode. Press the DG SLAVE
Softkey to deactivate DG mode.
Pressing the HDG- or HDG+ softkey to slew the heading
counterclockwise or clockwise.
Pressing the HDG SYNC softkey to synchronize the heading to the
current selected heading.
Pressing the TRACK SYNC softkey to synchronize the heading to the
current track.
CHANGE NAVIGATION SOURCES
1)
Press the CDI Softkey to change from GPS to VOR1 or LOC1. This changes
the NAV1 standby frequency in the upper left corner of the PFD to light
blue, indicating this is the frequency selected for tuning.
2)
Press the CDI Softkey again to change from VOR1 or LOC1 to VOR2 or
LOC2. This changes the NAV2 standby frequency in the upper left corner of
the PFD to light blue, indicating this is the frequency selected for tuning.
3)
Press the CDI Softkey a third time to return to GPS.
ENABLE/DISABLE OBS MODE WHILE NAVIGATING WITH GPS
1)
Press the OBS Softkey to select OBS Mode.
2)
Turn a CRS Knob to select the desired course to/from the waypoint. Press a
CRS Knob to synchronize the Selected Course with the bearing to the next
waypoint.
3)
Press the OBS Softkey again to disable OBS Mode.
Vue de la page 19
1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 173 174

Commentaires sur ces manuels

Pas de commentaire