
Garmin G1000 Cockpit Reference Guide for the Diamond DA42NG
190-00963-03 Rev. A 113
Annunciations & Alerts
Flight
Instruments EIS
Nav/Com/
XPDR/Audio AFCS GPS Nav
Flight
Planning Procedures
Hazard
Avoidance
Additional
Features
Abnormal
Operation
Annun/
Alerts Appendix Index
MISCELLANEOUS MESSAGE ADVISORIES (CONT.)
Message Comments
VNV
– Unavailable. Excessive track
angle error.
The current track angle error exceeds the limit,
causing the vertical deviation to go invalid.
VNV
– Unavailable. Excessive
crosstrack error.
The current crosstrack exceeds the limit, causing
vertical deviation to go invalid.
VNV
– Unavailable. Parallel course
selected.
A parallel course has been selected, causing the
vertical deviation to go invalid.
NON WGS84 WPT
– Do not use GPS
for navigation to [xxxx]
The position of the selected waypoint [xxxx]
is not calculated based on the WGS84 map
reference datum and may be positioned in error
as displayed. Do not use GPS to navigate to the
selected non-WGS84 waypoint.
TRAFFIC FAIL
– Traffic device has
failed.
The is no longer receiving data from the traffic
system. The traffic device should be serviced.
STRMSCP FAIL
– Stormscope has
failed.
Stormscope has failed. The system should be
serviced.
FAILED PATH
– A data path has failed. A data path connected to the GDU or the GIA
63W has failed.
FAILED PATH
– An autopilot servo
data path has failed.
A data path connected to an autopilot servo has
failed. Only available if Garmin AFCS is installed.
SVT
– SVT DISABLED: Out of available
terrain region.
Synthetic Vision is disabled because the aircraft is
not within the boundaries of the installed terrain
database.
SVT
– SVT DISABLED: Terrain DB
resolution too low.
Synthetic Vision is disabled because a terrain
database of sufficient resolution (9 arc-second or
better) is not currently installed.
SCHEDULER [#]
– <message>. Message criteria entered by the user.
CHECK CRS
– Database course for
LOC1 / [LOC ID] is [CRS]°.
Selected course for LOC1 differs from published
localizer course by more than 10 degrees.
CHECK CRS
– Database course for
LOC2 / [LOC ID] is [CRS]°.
Selected course for LOC2 differs from published
localizer course by more than 10 degrees.
[PFD1 or MFD1]
CARD 1 REM
– Card
1 was removed. Reinsert card.
The SD card was removed from top card slot of the
PFD or MFD. The SD card needs to be reinserted.
Commentaires sur ces manuels