
Garmin G1000 Cockpit Reference Guide for Mooney M20M & M20R
110
APPENDIX A
Miscellaneous Message Advisories (Cont.)
Alerts Window Message Comments
APPR TRG ALT – Approaching target
altitude.
Aircraft is approaching target altitude. Prepare to level aircraft.
LOCKED FPL – Cannot navigate locked
flight plan.
This occurs when the pilot attempts to activate a stored flight plan that contains
locked waypoint. Remove locked waypoint from flight plan. Update flight plan with
current waypoint.
WPT ARRIVAL – Arriving at waypoint
-[xxxx]
Arriving at waypoint [xxxx] where xxxx is the waypoint name.
STEEP TURN
– Steep turn ahead. A steep turn is 15 seconds ahead. Prepare to turn.
INSIDE ARSPC – Inside airspace. Aircraft is inside airspace.
ARSPC AHEAD – Airspace ahead less
than 10 minutes.
Airspace is ahead of aircraft. Aircraft will penetrate airspace within 10 minutes.
ARSPC NEAR – Airspace near – less
than 2 nm.
Airspace is within 2 nm of the aircraft position.
LEG UNSMOOTH
– Flight plan leg will
not be smooth.
The approaching flight plan waypoints are too close to make smooth turns. Prepare
for steep turns ahead and expect noticeable course deviations.
APPR INACTV – Approach is not
active.
The system notifies the pilot that the loaded approach is not active. Activate ap
-
proach when required.
SLCT AUTOSEQ
– Select auto se-
quence mode.
The system notifies the pilot to select auto-sequence mode. Press the OBS softkey to
deactivate the OBS mode.
SLCT FREQ – Select appropriate
frequency for approach.
The system notifies the pilot to load the approach frequency for the appropriate NAV
receiver. Select the correct frequency for the approach.
SLCT NAV – Select NAV on CDI for
approach.
The system notifies the pilot to set the CDI to the correct NAV receiver. Set the CDI
to the correct NAV receiver.
NO WGS84 WPT – Non WGS 84
waypoint for navigation -[xxxx]
The selected waypoint [xxxx] does not use the WGS 84 datum. Cross-check position
with alternate navigation sources.
TRAFFIC FAIL – Traffic device has
failed.
The traffic information system TIS has failed. Have the G1000 system serviced.
STRMSCP FAIL
– Stormscope has
failed.
The Stormscope has failed. Have the G1000 system serviced.
Commentaires sur ces manuels