Garmin Software Version 0424.01 Guide de l'utilisateur Page 63

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 130
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 62
Garmin G1000 Cockpit Reference Guide for Mooney M20M & M20R
49
SECTION 4 – MFD
Fuel Flow Indicator (Normally Aspirated)
The Fuel Flow indicator displays current fuel flow val-
ues, expressed in gallons per hour (GPH).
Fuel Pressure Indicator (Turbocharged Only)
The Fuel Pressure indicator displays current fuel sys-
tem pressure in pounds per square inch (PSI).
Green – Normal
Yellow – Caution (low and high)
Red – Warning (minimum and maximum)
Oil Pressure Indicator
The Oil Pressure indicator displays the pressure of
the oil supplied to the engine in pounds per square inch
(PSI).
Green – Normal
Yellow – Caution (low and high)
Red – Warning (minimum and maximum)
Oil Temperature Indicator
The Oil Temperature indicator displays the engine oil
temperature in degrees Fahrenheit.
Green – Normal
Red – Warning
EGT Indicator (Normally Aspirated)
The EGT (Exhaust Gas Temperature) indicator displays
the exhaust gas temperature of the hottest cylinder in de
-
grees Fahrenheit. The number of the associated cylinder
is indicated in the triangle pointer. The EGT indicator
does not have color bands.
TIT Indicator (Turbocharged Only)
The TIT (Turbine Inlet Temperature) indicator displays
the temperature at the turbine inlet in degrees Fahrenheit.
Green – Normal
Red – Warning
CHT Indicator
The CHT (Cylinder Head Temperature) indicator dis-
plays the temperature of the hottest cylinder in degrees
Fahrenheit. The number of the hottest cylinder appears
in the triangle pointer.
Green – Normal
Red – Warning
Voltmeter
The Voltmeter displays the battery and essential bus
voltage.
Ammeter
The Ammeter displays the alternator load in amperes.
Rudder Trim Indicator
The Rudder Trim indicator depicts the position (right/
left) of the rudder trim setting. Actual trim position is
shown using a blue inverted triangle. The ‘takeoff’ rudder
trim position is shown in white.
Elevator Trim Indicator
The Elevator Trim indicator depicts the position (up/
down) of the elevelator trim setting. Trim position is
shown by a blue triangle. A white block indicates ‘takeoff
elevator trim position.
Flaps Position Indicator
The Flaps Position Indicator shows the current posi-
tion of the flaps. The three possible positions, up, take-
off, and down, are depicted in cyan as ‘UP’, ‘T/O’, and
‘DN’, respectively. During flaps position transition, ‘///’ is
displayed in the window.
NOTE: The Lean and System pages are
described in detail in the G1000 Engine
Indication System Pilot’s Guide.
Vue de la page 62
1 2 ... 58 59 60 61 62 63 64 65 66 67 68 ... 129 130

Commentaires sur ces manuels

Pas de commentaire